Majestouch series use stabilizer components on larger keys to ensure parallel action, a steel rod, for bigger keys such as Shift, Space or Enter keys.
Stabilizer needs a small white lug to fix in place.
There is a direction on the small white component to place into fitting hole on the keycap just like the image shown below.

Place white parts with longer length in far side.

1. For Majestouch series, large-sized key of "Shift key", "space key" and "Enter key" are using stabilizers (part of wire). In order not to break the component and wire, it is necessary to remove prudently for these keys.

* Housing is taken off first for taking photos.

2. White component is located in backside of the key cap and wire is plugged into the hole.

3. While holding down the wire with precise driver, shift the key cap to side, which able to pull out the wire from the white component.
Please note when unreasonable power is applied, there is a possibility the component and wire might break.

4. Pull out the wire from the white component also on the other side to finish. To set the key cap again, procedure is done conversely above.